The Process

• Load the design into CorelDraw and draw the cut line.
   
• Print the photos or graphics with Epson C86 on JetCut Material.
   
• Laminate the sheet using our cold lamination.
   
• Print to your Stika FX to cut out the stickers.
   
• Weed of the waste.
   
• Tape down the sheet to the EUV work board.
   
• Apply Doming resin.
   
• Pass the bubble remover over the domes to remove air bubbles.
   
• Slide the work board into the EUV.
   
• Wait 15 minutes.
   
• Apply .

Here is what comes with the system

• EUV-80 80 watt ultraviolet curing system.(9” X 24” )
• ELM-9 cold laminator (9”)
• Stika SX 15-FX
• Instructional DVD
• Corel Draw 9
• InstaDome Add-ins
• Clip Art
• Bubble remover
• Application gun
• 25 Sheets JetCut base material
• 25’ roll of clear over laminate
• 32 oz. of InstaDOME resin
• 2 Applicator bottles